Placing Your Child In The Seat (A-E Illustrations) - Kinderkraft SPARK Bedienungsanleitung

EN

4.1 Placing your child in the seat (A-E illustrations)

Position the seat with its backrest firmly against the backrest of the car seat. Make sure that
the product is not placed on the safety belt buckle (A). Sit your child on the seat with his/her
back against the backrest (B). Put the seat belt around the child. Thread the lap belt under
both armrests (conform the red markings on the seat booster). Insert the buckle tongue in
the belt buckle (C1) and pull the lap belt tight (C2). Thread the shoulder belt under the
armrests back again and then over the shoulder through the (red marked) belt hook on the
headrest (D1). For maximum safety: again pull the shoulder belt tight in upwards direction
(D2). Make sure that the belt is not twisted (E).
4.2 Check the correct headrest height (G).
To ensure the correct headrest height is obtained, the belt hook should be located slightly
above the shoulders of your child (this distance should be between 0,5 and 2,5 cm). You can
adjust the height of the headrest by holding the backrest with one hand, and pull the
headrest upwards (or push it downwards) with your other hand at the top. When the next
position is reached, you hear a click.
Note!
• The tighter the belts are around the child, the better the protection. When your child is
complaining about too much tension, check if the shoulder belts are be adjusted to a higher
position. The space between the belt slots and the shoulders of your child should be
between 0,5 and 2,5 cm.
• The belts should never be twisted.
• If you are unable to click the tongue section in the buckle, unblock the buckle and try again.
• If you are not able to fasten the harness belt properly or pull it tight, contact your supplier
immediately. Under no circumstances use the product!
4.3 Removing the backrest from the seat booster (F)
Push the backrest (together with the headrest) downwards until you feel some resistance.
Gently push the backrest until it lies flat. Remove the backrest by lifting the hooks out of the
openings in the seat booster.
20