Kinderkraft SPARK Bedienungsanleitung Seite 19

● The Instructions can be retained with the child seat for its life period.
● Not to use any load bearing contact points other than those described in the instruction
and marked on the child car seat.
● Any rigid items and plastic parts of the child car seat must be so located and installed that
they are not liable, during everyday use of the vehicle, to become trapped by a movable
seat or in a door of vehicle.
● Periodically inspect the harness, pay particular attention to attachment points, stitching
and adjusting devices.
● Do not continue to use the child car seat if parts have become damaged or have loosened
after an accident.
● Ensure that all parts are locked in place correctly and not penned in the adjustable seats
or doors.
● Do not use this child seat at home. It's not designed for home use and should only be used
in your car.
● We recommend using the baby car seat on the back seat of cars.
● Before each journey check whether the child car seat is installed firmly.
● The back rest of the child car seat system has to rest flat against the back of the vehicle
seat. If necessary, adjust the head rest of the vehicle seat.
● The buckle of the safety car seat belt can't be too close to the below of armrest. Please
contact the child restraint manufacturer if in doubt about this point.
● When you drive without a child in the child restraint system, always secure the system
with the adult belt.
● Ensure that any lap strap is worn low down, so that the pelvis is firmly engaged, the belt Is
not twisted.
4. Installing the seat in the car with a 3-point car safety belt (1-2 illustrations).
The product can be fitted safely on almost all the seats in the car with the existing seat belts.
In some cases the buckle of the car belt may be too long and therefore sits too high against
the base of this product. Thus, the product cannot be fitted securely. In this case, choose
another position in the car.
Follow the instructions as shown on the instruction label placed on the side of the backrest.
We recommend that you place the seat on the rear seat in the car, facing forward. The seat
consists of three parts: an adjustable headrest, a backrest and a seat booster.
Mass Group II: Your child should only use the complete seat when he/she weighs at least 15
kg. Remove the headrest of the passenger seat being used if it causes an obstruction for
proper installation of the seat.
Mass Group III: When you child weighs about 22 kg, it should only use the seat booster of
this seat. Do not forget to replace the headrest of the passenger seat, when you use it with
only a seat booster.
The belt routing areas are marked in red. You will see a red mark under the armrests of the
booster and a red mark on the same height as both car belt hooks.
EN
19