Inhaltsverzeichnis
Werbung
Transmitter TX5 2,4 GHz
Safety Instructions
Read these instructions carefully before use paying particu-
lar attention to the safety notes. If this is your first venture into
radio controlled modelling we strongly recommend that you
seek the help of an experienced modeller before you begin.
This Radio control system has been exclusively designed for use
with models designed to be remotely controlled and as such may
only be legally operated as such. The company JAMARA accept no
responsibility whatsoever if his product is used in any other way.
Radio Controlled models, in particular aircraft, are not toys and as
such and should only be operated by children or youths if closely su-
pervised by a responsible adult. Building and operating such mod-
els requires a degree of skill, understanding and technical know-
how as well as a responsible attitude. Faults in the construction
or irresponsible behaviour could lead to serious damage or injury.
As neither the manufacturer or retailer has any influence over the
correct use of modelling products we wish to emphasise these safe-
ty instructions and will in no way be held responsible for the misuse
of our products. Please be aware that the receiver system can also
create a danger if operated when the transmitter is not switched on.
Always operate the TX5 2,4 GHz with extreme caution and
follow the instructions listed here. Always switch the trans-
mitter on before the receiver and switch off in the oppo-
site order. Only use our original receivers as any other brand
of 2.4 GHz receivers will not bond to our transmitters.
Protect the system from dust, dirt and moisture. Never expose the
system to extreme heat, cold or vibration. The system should only
be operated between - 10 and + 40
selected from our range and follow the battery manufacturers in-
structions.
Avoid exposing the system to impact or vibration and inspect all of
the components regularly for damage to the casing, plugs, sockets
and cables. If any component gets damaged or is exposed to water
do not use it even if it has been dried out! Any such component
should be replaced or returned to our service department
(included by RTF Version)
0
C. Use a good quality charger
Furthermore, the following should be strictly adhered to:
• The receiver battery must be charged before every flying
session.
• Before Switching on the system ensure that throttle stick is in
the off position.
• Check that the transmitter and receiver are compatible and
bonded to one another.
• Always switch the transmitter on first and then the receiver.
• Always switch the receiver off first and then the transmitter .
• Complete a full range and function test before every take-off.
• When flying, do not point the transmitter antenna directly at
the model as in this configuration the signal is at it's weakest.
Try to keep the antenna at right angles to the model.
• Never over-fly people and do not allow your model to endanger
people or animals.
• Do not fly near to over-head cables, buildings or airfields.
• The system must not be operated in rain, or thunder storms.
• If you do not intend to use the transmitter for a long period,
remove the batteries.
• Dispose of batteries and electronic waste correctly. These item
should not be placed in the household rubbish in most countries.
The system may not be altered in any way, doing so will void the
guarantee.
Indemnity Statement
As the company JAMARA has no influence over the use, main-
tenance or conditions under which our products will operate, we
accept no responsibility for any damage caused be it of a physical,
financial or theoretical nature. JAMARA Modelltechnik will accept
no claim against it which results directly or indirectly from the ope-
ration or use of its products.
Your Statutory Rights apply, any claim made against us
will be based solely on the retail price of the product, and
limited to the model only. This will not apply if we are proved
to be legally responsible or when gross negligence can be
proved.
9
Werbung
Inhaltsverzeichnis
