Herunterladen Inhalt Inhalt Diese Seite drucken

Grundig CDP-S 150 Betriebsanleitung Seite 6

Inhaltsverzeichnis

Werbung

Allgemeiner Teil / General Section
Ausbauhinweise
1. Gehäuseoberteil abnehmen
- 4 Schrauben A herausdrehen (Fig. 1).
- Gehäuseoberteil (mit CD-Fachdeckel) abnehmen.
A
A
Fig. 1
2. CD-Laufwerk ausbauen
Achtung: Die Lasereinheit ist sehr empfindlich gegen statische
Aufladungen (MOS-Bauteile)!
Deshalb muß vor Abziehen der Steckverbindung eine Schutzlötstelle
B (Fig. 2) auf der Flexprintleitung angebracht werden, um eine
Zerstörung der Laserdiode durch statische Aufladung zu vermeiden.
- Gehäuseoberteil abnehmen (siehe Pkt. 1).
- Flexprinthalter öffnen (Fig. 3).
- Flexprintleitung aus Flexprinthalter ziehen.
- Laufwerkzuleitungen von der Hauptplatte ablöten (S+/rot, S-/
schwarz, T-/orange, T+/blau, 2 x RST/weiß).
- Laufwerk herausnehmen.
Fig. 4
3. Hauptplatte ausbauen
- CD-Laufwerk ausbauen (siehe Pkt. 2).
- 2 Schrauben C (Fig. 4) und Schraube D (Fig. 5) herausdrehen.
- Batteriekontakte E (Fig. 4) und F (Fig. 5) aus dem Gehäuseunter-
teil herausziehen.
- Hauptplatte in Pfeilrichtung A (Fig. 4) anheben und herausnehmen.
1 - 6
A
B
A
1
1
Fig. 3
E
A
C
Disassembly Instructions
1. Removing the Top of the Cabinet
- Undo 4 screws A (Fig. 1).
- Remove the top of the cabinet (with the CD compartment lid).
Fig. 2
2
2. Removing the CD Drive Mechanism
Attention: The laser unit is very sensitive to static charges (MOS
components)!
Therefore the flexprint must be provided with a protective soldered joint
B (Fig. 2) before unplugging the connector to avoid damage to the
laser diode by static charges.
- Remove the top of the cabinet (see para 1).
- Open the flexprint holder (Fig. 3).
- Pull the flexprint out of its flexprint holder.
- Unsolder the drive mechanism connecting leads on the main
board (S+/red, S-/black, T-/orange, T+/blue, 2 x RST/white).
- Take out the drive mechanism.
F
D
Fig. 5
3. Removing the Main Board
- Remove the CD drive mechanism (see para 2).
- Undo 2 screws C (Fig. 4) and screw D (Fig. 5).
- Pull out the battery contacts E (Fig. 4) and F (Fig. 5).
- Lift the main board in the direction of the arrow A (Fig. 4) and take
it out.
CDP-S 150
GRUNDIG Service

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis