Further Safety Directions; Overview; Further Safety Instructions; General Description - Grizzly KSG 220 Originalbetriebsanleitung

GB
• If the supply cord of this power tool
is damaged, it must be replaced by
a specially prepared cord available
through the service organization.

Further Safety Instructions

• Connect the device only to a power
point with a residual current protective
device (RCD) with a measured residual
current of not more than 30 mA.
• Keep the mains cable and extension
cable away from the grinding disk and
saw chain. In the event that it is dam-
aged or severed, immediately discon-
nect the plug from the socket.
Do not touch the cable before it has
been disconnected from the mains.
Risk of electric shock.
• Before use, carry out a visual inspec-
tion of the grinding disk. Do not
use grinding disks that are spalled,
cracked or otherwise damaged. Re-
place a worn grinding disk.
• Never operate the device without the
visual protection disk.
• Do not work with the device if you
are tired or after the consumption of
alcohol or tablets. Always take a break
from the work in good time.
• Do not use the device in an explosive
atmosphere or where sparks could
cause fire, explosion etc. Failure to ob-
serve this will result in a risk of fire or
explosion.
• Keep your hands away from the grind-
ing disk and chain teeth when the
device is in use. Do not move the chain
by hand. This will cause a risk of in-
jury.
• Never place your fingers between the
grinding disk and rotary disk or be-
tween the grinding disk and protection
disk. This will cause a risk of crushing.
120
• The chain becomes hot during grind-
ing. Do not touch the machined loca-
tion, as there is a risk of being burnt.
• Use only grinding disks recommended
by the manufacturer. Do not use saw
blades.
• Switch off the device and disconnect at
the plug
- to release a jammed insertion tool,
- if the connecting cable is damaged
or tangled,
- in the case of unusual noises.

General description

Summary
1 Grinder housing
2 On/off switch
3 Grip
4 Fixing bolt for grinding disc cover
5 Grinding disc cover
6 Fixing bolt/washer for transparent co-
ver
7 Grinding disc
8 Transparent cover
9 Fixing bolt for saw chain
10 Stop
11 Adjusting screw for stop
12 Guide rail
13 Fixing drill hole for baseplate
14 Rotary table for fixing saw chain
15 Baseplate
16 Locking bolt for angle setting
17 Scale for sharpening angle (+35° to
-35°)
18 Drillhole for spindle lock
19 Fixing bolt/nut for grinder housing
20 Adjusting bolt for depth stop
21 Ventilation openings
22 Mains connection cable
23 Lock bolt
24 Jaw spanner
25 Box spanner