En Troubleshooting - JVC GR-D390AS Bedienungsanleitung

TROUBLESHOOTING
48
EN
The image taken using Snapshot is too
dark.
● Shooting was performed under backlit conditions.
➜Press BACKLIGHT. (
The image taken using Snapshot is too
bright.
● The subject is too bright.
➜Set "
" to "SPOTLIGHT". (
White Balance cannot be activated.
● The Sepia (SEPIA) or Monotone (MONOTONE)
mode is activated.
➜Disengage the Sepia (SEPIA) or Monotone
(MONOTONE) mode before setting White
Balance. ( pg. 42)
The image looks like the shutter speed is
too slow.
● When shooting in the dark, the unit becomes
highly sensitive to light when "GAIN UP" is set to
"AUTO".
➜If you want the lighting to look more natural, set
"GAIN UP" to "AGC" or "OFF". (
Other problems
The POWER/CHARGE lamp on the
camcorder does not light during charging.
● Charging is difficult in places subject to extremely
high/low temperatures.
➜To protect the battery, it is recommended to
charge it in places with a temperature of 10°C to
35°C. ( pg. 52)
● The battery pack is not attached firmly.
➜Detach the battery pack once again and re-attach
it firmly. ( pg. 14, 15)
"SET DATE/TIME!" appears.
● The date/time is not set.
➜Set the date/time. (
● The built-in clock battery has run out and the
previously set date/time has been erased.
➜Consult your nearest JVC dealer for replacement.
Files stored in the memory card cannot be
deleted.
● Files stored in the memory card are protected.
➜Remove protection from the files stored in the
memory card and delete them. (
pg. 40)
pg. 42)
pg. 32, 34)
pg. 17)
pg. 29)
When the image is printed from the printer,
a black bar appears at the bottom of the
screen.
● This is not a malfunction.
➜By recording with "DIS" de-activated (
this can be avoided.
When the camcorder is connected via the
DV connector, the camcorder does not
operate.
● The DV cable was plugged/unplugged with power
turned on.
➜Turn the camcorder's power off and on again,
then operate it.
Images on the LCD monitor appear dark or
whitish.
● In places subject to low temperature, images
become dark due to the characteristics of the
LCD monitor. This is not a malfunction.
➜Adjust the brightness and angle of the LCD
monitor. ( pg. 18, 20)
● When the LCD monitor's fluorescent light reaches
the end of its service life, images on the LCD
monitor become dark.
➜Consult your nearest JVC dealer.
Coloured bright spots appear all over the
LCD monitor or the viewfinder.
The LCD monitor and the viewfinder are made with
high-precision technology. However, black spots or
bright spots of light (red, green or blue) may appear
constantly on the LCD monitor or the viewfinder.
These spots are not recorded on the tape. This is
not due to any defect of the unit. (Effective
dots: more than 99.99%)
The cassette will not load properly.
● The battery's charge is low.
➜Install a fully charged battery. (
The memory card cannot be removed from
the camcorder.
➜Push in the memory card a few more times.
( pg. 19)
pg. 32, 33)
pg. 14)