Getting The Password For Authentication; Upgrade Procedures; Upgrading The Software Programme And The Map Database - Pioneer T1000-19327 Benutzerhandbuch

Instructions for upgrading
4 Write down your device number
(Device Number) onto the supplied Media
Number Card (MEDIA NUMBER CARD) to
avoid mistakes.
p Also write down "Version" information
which would be used to confirm completion
of the update.
Getting the password for
authentication
For upgrade, a unique password issued online
is necessary. Access the website with your PC
and get your password.
The following information is required.
! Media Number (MEDIA NUMBER) printed
on supplied Media Number Card
(MEDIA NUMBER CARD)
! Device Number (DEVICE NUMBER) of your
navigation system
1 Access on the following website to
issue your password.
http://www.pioneer.eu/UnlockNavgate
For issuing the password, follow the instruc-
tion on the website.
2 Record the password that you received.
You need to input this password accurately.
Write down your password to avoid mis-
takes.

Upgrade procedures

NEVER stop the engine of your vehicle or turn
off the power supply to the navigation system
until the installation is completed. Turning the
power off during upgrade process causes a
malfunction or failure of the navigation sys-
tem.
Upgrading the software
programme and the map database
This section describes the upgrade proce-
dures for your navigation system.
p The upgrade takes approximately 30 min-
utes in total.
1 Park your vehicle in a safe place and
apply the handbrake.
2 Insert the upgrade SD memory card
into the SD card slot.
The message confirming whether or not to
start the update will appear.
3 Touch [OK].
4 Touch [Yes].
After a short pause, the keyboard for entering
the password will appear.
# Touch [No].
Shows the device number (Device #) of your navi-
gation system.
# Touch [Cancel].
Cancels the update.
5 Enter the password for authentication
that you obtained, then touch [OK].
Chapter
04
17
Engb