Caller Id/Clip; Setting The Date And Time - Topcom butler 1200 Bedienungsanleitung

Butler 1200/1210
• 'NOT SUB' appears on the display. The handset is completely reinitialised.
Afterwards, you must resubscribe all handsets as described in point 4.21! However you no
longer need to set the base unit to subscription mode, because this now happens automatically!

5 CALLER ID/CLIP

(This service only works when you have a Caller ID/Clip subscription. Contact your telephone
company).
When you receive a call, the telephone number of the caller, the date and time appears on the
handset display. The telephone can receive calls in both FSK and DTMF. If the name is program-
med in the Phone Book, the name in the Phone Book is displayed!
The telephone can store 30 calls in a Call List that can be reviewed later. The telephone never
stores the same call twice. When the memory is full, the new calls automatically replace the
oldest calls in the memory. The symbol
answered. If the Call List is empty and you press the Up key
You can view the information of an incoming call as follows:
• Press the Up key
of the caller, the sequence number of the call in the Call List, the date and time of the call
appear on the display.
• Press the Down key

5.1. Setting the date and time

When you receive an incoming call and the date and time are not sent together with the
telephone number, this means that the date and the time will not be shown on the display. By
setting the date and time, they will be shown on the display, together with the telephone
number, every time a call comes in !
• Press the Programming key
• Press the Up or Down key
• Press the Programming key
• 'DATE/TIME' appears on the display.
• Press the Programming key
• When 'YEAR' appears on the display, enter the 2 last numbers of the year (00=2000,
01=2001, ...) and press the Programming key
• When 'MONTH' appears on the display, enter the month (01=January, 02=February, ...) and
press the Programming key
• When 'DAY' appears on the display, enter the day of the month and press the Programming
key to confirm.
on the display blinks if the call is not read or not
. The name (if sent by the network or present in the Phone Book memory)
. The telephone number of the caller appears on the display.
.
a few times until 'SETTING' appears on the display.
.
again.
to confirm.
, three beep tones will sound.
to confirm.
68