Subscribing Butler 1210 Handset On Butler 575/575+ & Cocoon100/100+ & Butler 2000 Base Unit - Topcom butler 1200 Bedienungsanleitung

Butler 1200/1210
The underlined procedure is only applicable to a Butler 1000, 1010, 1210 handset and base
unit!!
Keep the Paging key
on the base unit begins to blink rapidly. The Line/Charge indicator
for one minute. During this minute, the base unit is in subscribing mode and you must do the
following to subscribe the handset:
• Press the Programming key
• Press the Up or Down key
• Press the Programming key
• 'BASE _' appears on the display.
• Enter a number of the base unit you would like to subscribe the handset to (1-4).
Use the number keypad.
Note: Each handset can be subscribed to 4 different DECT base units. Each base unit is assigned a
number from 1 to 4 in the handset. When you subscribe a new handset, you can assign a base unit
number. It is best to use '1' .
• 'SEARCHING' and the symbol
• The RFPI code (each base unit has a unique RFPI code) appears on the display and a signal
sounds when the handset has found the base unit.
• Press the Programming key
• 'PIN' appears on the display.
• Enter the 4-digit PIN code of the base unit in (default PIN code is '0000'). Use the number
keypad.
• Press the Programming key
• The handset is subscribed to the base unit.
4.23 Subscribing Butler 1210 handset on Butler 575/575+ & Cocoon100/100+ &
Butler 2000 base unit
Press the Paging key
for +/- 15 seconds until you hear a beep. The base unit is now in subscribing mode. For 1
minute, the base unit is in subscribing mode and you have to do the following to subscribe the
handset:
• Press the Programming key
• Press the Up or Down key
• Press the Programming key
• 'BASE _' appears on the display.
• Enter a number for the base unit to which you would like to subscribe the handset (1-4).
Use the number keypad.
• 'SEARCHING' and the symbol
• The RFPI code (each base unit has a unique RFPI code) appears on the display and a signal
sounds once the base unit is found by the handset.
• Press the Programming key
• 'PIN' appears on the display.
• Enter the 4-digit PIN code of the base unit (default PIN code is '1590'). Use the number keypad.
• Press the Programming key
• The handset is subscribed to the base unit.
on the base unit pressed for 10 seconds until the Line/Charge indicator
.
repeatedly until 'BASE SUB' appears on the display.
.
appears on the display.
.
.
on the Butler 575/575+ or Cocoon100/100+ or Butler 2000 base unit
.
repeatedly until 'BASE SUB' appears on the display.
.
appear on the display.
.
.
64
will blink rapidly