Default Settings (Reset)Of The Parameters; Complete Reinitialisation Of The Telephone - Topcom butler 1200 Bedienungsanleitung

Butler 1200/1210
• Enter the numbers of the handsets from which the barred numbers cannot be called.
• e.g. Press the number key 2, 3 and 5. On the display, this will appear: HS _2 3_5 01486
These handsets can no longer dial numbers beginning with '01486'.
• Press the Programming key
Repeat the same procedure described above if you would like to bar other numbers (max. 5)!
4.28 Default settings (reset) of the parameters
You can reset the standard (default) settings in the telephone so that they are the same they
were when you bought the telephone. You need the PIN code to do this.
The default settings are:
Keypad:
Key clicks:
Speaker volume:
Ringer melody:
Ringer volume :
Selection base unit:
Flash time:
To restore the default settings, do the following:
• Press the Programming key
• Press the Up or Down key
• Press the Programming key
• Press the Up or Down key
• Press the Programming key
• 'PIN' appears on the display.
• Enter your PIN code.
• Press the Programming key

4.29 Complete Reinitialisation of the telephone

This function allows you to completely reinitialise the telephone without requiring your PIN
code. This will delete all Phone Book memory entries, all handsets will be removed, all default
settings will be restored and the default PIN code will be restored to '0000'.
Do the following:
• Disconnect the battery in the telephone.
• Keep the '*' key pressed and reconnect the battery until the handset rings continually and
the display lights up. Release the '*' button and press the Programming key
• The handset finds the base unit and a signal sounds.
• Briefly press the '*' key.
• 'RESET ?' appears on the display.
• Press the Programming key
discontinue the procedure.
• 'RESETTING' appears on the display and a long beep tone sounds.
to confirm your selection.
not locked
active
level 3
1
5
automatic
100ms
.
repeatedly until 'SETTING' appears on the display.
.
repeatedly until 'RESET' appears on the display.
.
.
to confirm your selection of disconnect the battery to
67
.