Items Supplied; Before Using For The First Time; Remote Control; Setting Up / Wall Mounting - Silvercrest SSB 40 A1 Bedienungsanleitung

4. Items supplied

1 soundbar
1 power unit 11
1

remote control

1 CR2025 3 V battery (inserted)
1 stereo cinch cable 12
2x4 screws 29 (25 mm / 50 mm)
4 rawlplugs 30
2 wall brackets 13
1 drilling template
1 copy of the user instructions
• Remove all packing material.
• Check that the device is undamaged.
If the delivery is incomplete or defective, please contact the
responsible service centre of the manufacturer (see "War-
ranty of the HOYER Handel GmbH" on page 10).
Please observe the illustrations on the fold-out page.
5. Before using for the first
time
5.1 Remote control
Initial use
• Remove the transport lock from the battery compart-
ment and remote control.
Changing the battery
DANGER OF EXPLOSION! If the battery is not
correctly replaced. Replace only with the same or
an equivalent type.
1. FIGURE A: remove the battery mount by unlocking it
and pulling it in the direction of the arrow.
2. Replace the old battery with a new one.
WARNING! When inserting the battery, note the
polarity marking on the battery mount.
3. Reinsert the battery mount.

5.2 Setting up / Wall mounting

NOTE: if you connect the device to a television set, place
the device as centrally as possible below the set.
Setting up
1. Place the device on a level surface.
2. Connect the power unit 11 to the device.
Wall mounting
WARNING! Risk of material damage!
Please ensure the following when mounting on a wall:
- The fixing material must be matched to the proper-
ties of the wall. If necessary, use fixing material other
than that supplied.
- Make sure that in the installation location there are
no pipes or cables in the wall (e.g. electricity, water,
gas).
- If necessary, have the wall mounting carried out by
an expert.
In connection with the wall mounting, use HDMI right
angle plugs so the plugs cannot be damaged by kinks.
1. FIGURE B: drill 2 holes per wall bracket 40 cm apart.
If necessary, use the enclosed drilling template.
2. For the enclosed rawlplugs, use a drill with a diameter
of 5 mm.
3. Insert the rawlplugs 30 into the drill holes.
4. Fasten the wall brackets 13 firmly to the wall using the
screws 29.
5. Insert all of the cables used into the connections (see
"Overview - Connections" on page 6).
6. Connect the power unit 11 to the device.
7. Hook the device into the wall brackets 13. Both wall
brackets 13 must engage safely into the holder on the
rear of the device.
5
GB