Hendi 239698 Gebrauchsanweisung Seite 6

Operation
• Put the plug in the socket.
• Set the pan of your choice on the cooking sur-
face, bearing the above-mentioned instructions in
mind. NOTE! Make sure that the pans are covering
the indicated zones at all times during use in order
to prevent the appliance from getting damaged. Do
not leave your pan on the burner while empty as
this may lead to damage to your pans.
• Switch the appliance on by pressing the "ON/OFF"
and then the "ARROW UP" key. If your pan is suit-
able for induction and has a bottom diameter of 14
cm, at minimum, the appliance will go into opera-
tion. You will recognise this from the fact that the
fan will go on and the display will show a capacity
position of "2000". NOTE! If the appliance beeps
after being switched on, the pan you are using is
not suitable for induction or the appliance is de-
fective. In case of any doubt, always contact the
supplier of your pan!
• Once the appliance is operating and the display
indicates position "2000", you can programme the
appliance in one of the following two ways:
1. Capacity control: You can control the performance
EN
of the appliance, just as for a gas cooker via 17 po-
sitions ranging from 100W to 3500W. The default
position for the appliance is "2000".
2. Temperature control: you can set the tempera-
ture between 35°C and 240°C in 5°C increments.
Standard position for the appliance is 100°C. AT-
TENTION! The programmed temperature is that
Error codes
E01 Overheated of the PCB (internal temperature in
the housing is too high, clean the filter or the air
inlet or outlet is blocked).
E02 Dry head or the temperature of the glass is too
Cleaning and maintenance
• Always remove the plug from the socket before
cleaning the appliance.
• Beware: Never immerse the appliance in water or
any other liquid!
• Clean the outside of the appliance with a damp
cloth (water with mild detergent).
• Never use aggressive cleaning agents or abra-
sives. Do not use any sharp or pointed objects. Do
6
of the glass plate and not the temperature in the
pan!
• If you choose capacity control, select "heating"
using the " Temp/heating" key. Now you can pro-
gramme the capacity required by means of the ar-
row keys, 3500W being the highest and 100W the
lowest position.
• If you select temperature control, select "Temp"
using the "Function" key. Now you can programme
the required temperature by means of the arrow
keys between 35°C and 240°C in 5°C intervals.
• After programming the capacity or temperature,
you can opt to programme the timer. This timer
switches the appliance off after the programmed
time has been reached. You do this by pressing the
"Timer" key once more after programming the ca-
pacity or temperature, and selecting "Timer". You
can now set the desired time. The maximum pro-
grammable time is 180 minutes.
• Once you have reached the required result, you can
switch off the appliance by pressing the "ON/OFF"
key. The display will go off and the lights next to
"Power", "Temp" and "Timer" will go off.
• If you do not use the appliance for an extended
period, remove the plug from the wall-mounted
electrical socket and remove the pans from the
appliance.
NOTE! Allow the appliance to cool off before you
touch it. The glass plate is very hot after use.
high (empty pot on the stove).
E03 Abnormal input voltage (using a generator or
similar in some times).
not use petrol or solvents! Clean with a damp cloth
and detergent if necessary. Do not use abrasive
materials.
• Clean the fan openings with the vacuum cleaner.
• Clean the glass plate each time after use. This is to
prevent any residues from burning onto the glass
plate.