Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
DO206SW
head. Gently but fi rmly push until the edging tool locks into place.
2. Insert the lower handle - small end - into the sweeper power head. Fix the handle
with the included screw.
3. Assemble the extension on the lower handle.
Please the telescopic tube on to the extention.
Push fi rmly.
4. Place the handle into the upward
storage position.
5. Plug the charging adapter into the sweeper
power head charging jack. Plug the charging
adapter cord into a standard electrical outlet.
HOW TO OPERATE YOUR CORDLESS SWEEPER
1. Before using, please ensure that the cordless
sweeper has been initially charged for 16-20 hours .
Your cordless sweeper will only operate properly when
the batteries are fully charged. Your sweeper will operate
for varying lengths of time on a full charge. This will depend
upon the type of surface being cleaned. (Longer operating
time on bare fl oors vs carpets.)
2. Push the On/Off switch to operate the unit. To turn off, press switch again.
CAUTION: Any electronic or electrical appliance should not be stored in or
exposed to areas of high heat or humidity. Do not store your cordless sweeper
close to stoves, radiators, furnaces or in a bathroom or bathing area.
3. To release the handle to a comfortable position, apply pressure to the top of the
sweeper head with your foot while pulling back on the handle.
4. To change the speed of the sweeper, press on the speed control button. As you press
on it, the speed indicator light will change. If one light lights up, then you have the
low speed, two light, medium speed, three lights, high speed.
5. If the brush roll will jam, all the lights will fl ash. Turn unit off, remove obstruction
and then turn on again to restart.
CLEANING THE DUST CONTAINER
1. Pull the dust container straight out from the side.
2. Empty dust container contents. If desired- you
may rinse with water to clean the dust container - but dry thoroughly before replacing
on the sweeper.
3. Replace dust container on cordless sweeper.
4. Periodically remove the transparent brush cover on the front of the cordless
sweeper and remove any build up of lint, hair or fi ber on the rotating brush. To
29
Werbung
Inhaltsverzeichnis
