Cleaning And Maintenance - Domo DO1033S Gebrauchsanleitung

USE
1. Unwind the cord to a substantial length and plug in the vacuum cleaner. The yellow label on the cord
indicates the maximum length of the cord, that should not be exceeded.
2. To turn the vacuum cleaner on and off, press the foot pedal with the
3. When you want to clean hard floors, make sure that the brushes in the floor
nozzle are down
4. When you want to clean carpet, make sure that the brushes in the floor nozzle
are retracted
5. Slide the valve on the hose into the closed or open position to increase or
reduce the suction power.
6. When you have finished vacuuming, unplug the vacuum cleaner and
automatically rewind the cord by pressing the foot pedal with the
plug does not whip back and forth while rewinding the cord, by guiding the cord with your hand.
This to prevent possible damage.

CLEANING AND MAINTENANCE

CHANGING THE DUST BAG
The vacuum cleaner cannot be used without the dust bag. When the dust bag is full or damaged you need
to replace it immediately. The dust bag full indicator turns red when you need to replace it.
1. Remove the flexible hose.
2. Open the top of the dust bag reservoir via the cover.
3. Pull the dust bag holder towards you to remove the dust bag and place a new one in the correct
position. Make sure that the dust bag is fixed into place under the dust bag holder.
THE FILTERS
The appliance has 2 filters. In a normal cleaning session, it is sufficient to tap out the filters. It is
recommended that you thoroughly clean the filters under tepid running water 3 to 4 times per year.
Make sure that it is completely dry before putting it back in the appliance. You can also replace them if
necessary. Avoid direct sunlight or intense overheating. Never put the filters in the washing appliance to
prevent deformation. Do not use abrasive or cleaning products and wash from the bottom of the filter.
EPA filter
Remove the EPA filter through the provided valve. Clean it thoroughly under tepid running water. Allow
it to air-dry properly. It is recommended that this filter be replaced once a year. Place all the parts back in
the vacuum cleaner before using the appliance again.
24
DO1033S
(A).
(B).
2
1
symbol.
symbol. Make sure that the
3
A
B