Machine Information; Technical Specifications - Ferm PDM1049P_K Originalbetriebsanleitung

2. MACHINE INFORMATION

Intended use
Your impact drill has been designed for drilling
holes in wood, metal and plastics and for hammer
drilling in brick and concrete.

Technical specifications

Mains voltage
Mains frequency
Power input
No-load speed
Impact rate
Max. chuck size
Max. drill diameter
Wood
Concrete
Steel
Weight
Noise values
Sound pressure (L )
PA
Acoustic power (L )
WA
Vibration values
Drilling into metal, a
h,D
Impact drilling into concrete, a
Vibration level
The vibration emission level stated in this
instruction manual has been measured in
accordance with a standardised test given in
EN 60745; it may be used to compare one tool
with another and as a preliminary assessment of
exposure to vibration when using the tool for the
applications mentioned
- using the tool for different applications, or with
different or poorly maintained accessories,
may significantly increase the exposure level
- the times when the tool is switched off or when
it is running but not actually doing the job, may
significantly reduce the exposure level
Protect yourself against the effects of vibration by
maintaining the tool and its accessories, keeping
your hands warm, and organizing your work
patterns.
4
220-240 V~
50 Hz
710W
0-3.200 /min
0-51.200 /min
13 mm
25 mm
13 mm
10 mm
2.20 kg
91.38 + 3 dB(A)
102.38 + 3 dB(A)
2.640 + 1.5 m/s
2
13.363 + 1.5 m/s
2
h,ID
Description
The numbers in the text refer to the diagrams on
page 2.
Fig. A
1. Chuck
2. Function selection switch
3. Depth stop
4. Lock-on button
5. On/Off switch
7. Left/right rotation switch
8. Side handle
9. Function selection: Hammer drilling
10. Function selection: Drilling
Fig. B
11. Rear sleeve
12. Front sleeve
3. OPERATING
Impact drills require very little operator
pressure. Excessive pressure on the tool
can lead to unnecessary overheating of
the motor, and burning of the driven tool.
Side handle
Fig. A
The side handle (8) can be rotated 360
the drill head, enabling safe and comfortable
operation for both left and right-handed users.
• Loosen the side handle (8) by turning it
anticlockwise.
• Rotate the side handle to the desired position.
• Retighten the side handle in the new position
by turning it clockwise
Exchanging and removing drill bits
Fig. A - B
Before exchanging bits, first remove the
power plug from the wall socket.
Inspect bits regularly during use. Blunt
bits should be re-sharpened or replaced.
• Open the chuck (1) by turning the front
sleeve (12) clockwise while simultaneously
holding the rear sleeve (11) or turning it
counterclockwise and insert the bit into the
chuck opening.
around
0