Team International FT 23 Gebrauchsanleitung Seite 11

Fax +32 2 359 95 50
PREHEATING
When the appliance has been switched on, set the thermostat on the desired temperature.
To reach a stable and correct temperature for use, it is necessary to wait 10 to 15 minutes.
During this time, the temperature control light will go on and off several times.
A good preheating will allow you to have browned and crispy fries.
USE
• Plug in the appliance.
• Set the thermostat to the desired temperature. Then set the timer: either put it in the "ON"
position for continuous functioning or set an operating time (from 0 to 30 minutes). The
indicator lamps will illuminate. As soon as the desired temperature is reached, the pilot
light will go out. When the temperature falls, the thermostat will be activated again, and
the pilot light will illuminate. It will go out again as soon as the temperature is reached. This
cycle will go on during use.
• CAUTION: IF YOU DO NOT USE THE TIMER FOR CONTINUOUS FUNCTIONING, THE APPLIANCE
WILL SWITCH OFF AUTOMATICALLY AT THE END OF THE SET TIME.
• When the fryer has reached the desired temperature, raise the basket by moving the
handle upwards until you hear a 'click'. Now open the lid by pressing its release button.
• Place the food into the basket slowly to avoid splashes and close the lid.
•
Lower the basket fully into the oil or fat by pulling at the handle release button and
swinging the handle down.
• Use the viewing window to check the food. When the food is ready, raise the basket by
lifting the handle and let the food drain. Then open the lid by pressing its opening button.
Warning: be careful when you open the lid, as hot steam may come out. Be careful not to
get burned.
• If necessary you can take the basket out of the appliance. Caution: do not pull the handle
release button when taking out the basket, as the latter would then fold in two and fall in
the oil causing splashes that could burn you.
•
Ensure the food is thoroughly cooked inside and out.
• After use, turn the thermostat to "MIN" and the timer to "OFF", unplug the appliance and let
its lid open to accelerate the cooling down.
FOR BEST RESULTS
• Always dry food well before frying. Very 'wet' food can cause the oil to 'foam' and may
overflow.
• Food for frying should be roughly of the same size to ensure the food cooks evenly and
thoroughly.
• Many types of food may need to be coated before frying - typical coatings are batter or
breadcrumbs.
• Always wait until the fryer has reached the desired temperature and the pilot light has
gone out, before adding the food.
• Do not overfill the basket.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don't change the page numbering. Keep the
language integrity.
11
Assembly page 11/40
TEAM FT 23 - 110720