Using Your Coffee Maker; Cleaning And Maintenance - RUSTA 903013930101 Gebrauchsanweisung

USING YOUR COFFEE MAKER

1. Open the water tank lid and fill the water tank with cold drinking water. The water level
should not exceed the MAX level as indicated on the water gauge.
2. Swing the funnel holder out, put the funnel into the funnel holder, then place the filter paper
in the funnel. Make sure it is assembled correctly.
3. Add ground coffee into the paper filter. Usually one cup of coffee needs one level spoon of
ground coffee, but you may adjust according to personal taste. Close the funnel holder. A click
will be heard when the funnel holder is closed completely.
4. Place the coffee pot horizontally on the warming plate.
5. Plug the power cord into the power outlet.
6. Press the switch down. The indicator will be illuminated. The appliance will begin working.
NOTE! During the brewing process, you may remove the coffee pot to serve coffee
for a duration of no more than 30 seconds, and the coffee maker will stop dripping
automatically. If the serving time exceeds 30 seconds, the coffee will overflow the funnel.
7. Once the coffee is brewed, one minute after the coffee stops dripping out, remove the
coffee pot, pour and serve.
NOTE! The brewed coffee you get will be slightly less than the water you have added as
some water is absorbed by coffee powder. DO NOT touch cover, warming plate and so
on when operating as they are very hot.
8. Once the process is finished, if you do not want to serve immediately, leave the appliance
on. The coffee maker will switch off autmatically after 40 minutes. For an optimum
coffee taste, serve just after brewing.
9. Always turn the coffee maker off and disconnect the power supply after use.
NOTE! Be careful when pouring the coffee out, as you may burn yourself as freshly
brewed coffee is very hot.

CLEANING AND MAINTENANCE

CAUTION! Always unplug the product from electrical outlet and allow the warming plate to
cool completely before cleaning it. Never immerse the unit or power cord into water or any
other liquid for cleaning.
1. Clean all detachable parts after each use in hot, soapy water.
2. Wipe the product's exterior surface with a soft, damp cloth to remove any stains.
3. Water droplets may build up in the area above the funnel and drip onto the product base
during brewing. To control the dripping, wipe off the area with a clean, dry cloth after
each use of the product.
4. Use a damp cloth to gently wipe the warming plate. Never use abrasive cleaner to clean it.
5