Daily Use; Setting And Starting A Programme - Electrolux GA55GLVSW Benutzerinformation

8.2 How to fill the rinse aid
dispenser
CAUTION!
Only use rinse aid specifically
designed for dishwashers.

9. DAILY USE

1. Open the water tap.
2. Press the on/off button to activate the
appliance.
Make sure that the appliance is in user
mode.
• If the salt indicator is on, fill the salt
container.
• If the rinse aid indicator is on, fill
the rinse aid dispenser.
3. Load the baskets.
4. Add the detergent.
5. Set and start the correct programme
for the type of load and the degree of
soil.
9.1 Using the detergent
A
A
A
+ -
B
30
20
C
1. Press the release button (D) to open
the lid (C).
2. Fill the dispenser (A) until the rinse aid
reaches the marking ''MAX''.
B
3. Remove the spilled rinse aid with an
absorbent cloth to prevent too much
foam.
4. Close the lid. Make sure that the
release button locks into position.
C
D
1. Press the release button (B) to open
the lid (C).
2. Put the detergent, in powder or
tablets, in the compartment (A).
3. If the programme has a prewash
phase, put a small quantity of
detergent on the inner part of the
appliance door.
4. Close the lid. Make sure that the
release button locks into position.
9.2 Setting and starting a
programme
The AUTO OFF function
This function decreases energy
consumption by deactivating automatically
the appliance when it is not operating.
The function comes into operation:
• 5 minutes after the completion of the
programme.
• After 5 minutes if the programme has
not started.
You can turn the selector of
the released quantity (B)
between position 1 (lowest
quantity) and position 4
(highest quantity).
Factory setting: level 4.
CAUTION!
Only use detergent
specifically designed for
dishwashers.
ENGLISH 13