Bass-Control; Gain-Control - Omnitronic MX-420 Bedienungsanleitung

25. LINE INPUT-SOCKETS
Additional RCA and 3.5 mm mono-jack input sockets for CH-4/LINE 10.
Connect line sources like MP3-players via the 3.5 mm mono-jack socket. Make sure that the LINE/MIC-
switch is set to LINE.
26. MASTER LEVEL DISPLAY
The display shows the level of the left and right master output. Note that it does not affect the record and
booth outputs.
27. TREBLE-CONTROL
Used to increase or lower the HIs of the individual input signal.
28. MIDDLE-CONTROL
Used to increase or lower the MIDs of the individual input signal.

29. BASS-CONTROL

Used to increase or lower the LOWs of the individual input signal.

30. GAIN-CONTROL

Used to set the level of the individual input signal. You can monitor the signal level via the Channel Display
(13). Reduce GAIN if the display´s red LEDs light up.
31. PHONO / LINE / MIC-SWITCH
Used to select the input to be sent to the individual channel. Make sure that the PH/LINE or LINE/MIC-switch
on the rear panel is set properly.
25/28 10006755_V_1_0.DOC