Internal Cleaning; Troubleshooting - Electrolux ESL 6810RA Benutzerinformation

36 www.electrolux.com
Only use neutral detergents. Do not use
abrasive products, abrasive cleaning pads
or solvents.

9.4 Internal cleaning

If you regularly use short duration pro-
grammes, these can leave deposits of
grease and limescale inside the appliance.

10. TROUBLESHOOTING

The appliance does not start or it stops
during operation.
An intermittent acoustic signal operates.
Before you contact the Service, refer to
the information that follows for a solution
to the problem.
Display
Attention: no intake of wa-
ter possible.
Attention: water is not
draining.
Attention: The anti flood
system has been activated.
WARNING!
Deactivate the appliance before
you do the check.
Problem
You cannot activate the appli-
ance.
The programme does not start.
The appliance does not fill with
water.
To prevent this, we recommend to run
long duration programmes at least 2
times per month.
With some problems, the display
shows a message and the Time Beam
shows an alarm code.
Time Beam
Possible solution
Make sure that the mains plug is connected
to the mains socket.
Make sure that there is not a damaged fuse in
the fuse box.
Make sure that the appliance door is closed.
Press OK .
If the delay start is set, cancel the setting or
wait for the end of the countdown.
Make sure that the water tap is open.
Make sure that the pressure of the water sup-
ply is not too low. For this information, con-
tact your local water authority.
Make sure that the water tap is not clogged.
Make sure that the filter in the inlet hose is not
clogged.
Problem
The appliance does not fill
with water.
The appliance does not
drain the water.
The anti-flood device is
on.