Mounting Accessories Included; Electrical Connection - AEG DI 8820 Benutzerinformation

Mounting accessories included

1 Reduction flange Ø 150-125
1 Deflector
6 Wood-screws 6 x 70 mm
6 Wall plugs Ø 10 mm
14 Nuts
4 Metal-screw 3 x 9 mm (2 upper chimney fixing + 2 for chimney brackets)
14 Metal-screw 4 x 8 mm (4 for additional structure fixing + 10 to fix hood to structure)
14 Metal-screw 4 x 7 mm (to fix chimeny sections)
2 Chimney brackets (only for HI 8820 / DI 8820)
14 fixing springs

Electrical connection

Safety warnings for the electrician
The mains power supply must correspond to the rating indicated on the
plate situated inside the hood. If provided with a plug connect the hood
to a socket in compliance with current regulations and positioned in an
accessible area. If it not fitted with a plug (direct mains connection) or if
the plug is not located in an accessible area apply a double poled
switch in accordance with standards which assures the complete
disconnection of the mains under conditions relating to over-current
category III, in accordance with installation instructions.
IMPORTANT! Before re-connecting the hood circuit to the mains
supply and checking the efficient function, always check that the mains
cable is correctly assembled.
70