Control Panel - AEG DI 8820 Benutzerinformation

Control Panel

• Best results are obtained by using a low speed for normal conditions
and a high speed when odours are more concentrated.
Turn the hood on a few minutes before you start cooking.
The hood should be left on after cooking for about 15 minutes or until
all the odours have disappeared. The control switches are located
on the hood's front panel:
1
Fig. 3
1 - Mains switch, ON/OFF
Press for less than 1 1/2 seconds and the cooker hood goes into the "stand by"
position (point "b" is illuminated).
Press for more than 1 1/2 seconds and the cooker hood turns off, ALL the controls
(except the light push button) are disabled (the display is off).
Press again for more than 1 1/2 seconds to reset the cooker hood to "stand by".
2 - Light ON/OFF
3 - Display
4 - Start and choice of motor speed 1-2-3-1-2.........
5 - Intensive speed on/off. The Intensive speed runs for 5 minutes:
If the hood is on when the Intensive speed is activated, the hood will revert to
previous speed after 5 minutes.
If the hood is off when the Intensive speed is activated, the hood will automatically
turn off after 5 minutes.
To interrupt the Intensive speed, press button 1 or 5.
The letter P appears on the display and the remaining time (the point "a" is
flashing), if interrupted an acoustic signal is heard.
6 - Self-Timer: times all the speed levels (the point "b" is flashing), and then the
cooker hood switches off:
The self-timer is set as follows:
The display shows the remaining operation time, at the end of the time an acoustic
signal is heard. Depressing the push-button again exits the function.
Should the hood or the controls fail to operate: disconnect the power supply for at least 5
seconds. After reconnecting the power supply wait 15 seconds and then check that the
cooker hood is now operating
correctly.
62
a b
2 3 4 5
1 speed level 20 minutes
st
2 speed level 15 minutes
nd
3 speed level 10 minutes
rd
6