Hama TS36E Bedienungsanleitung Seite 10

• The setup process is completed
when the indoor and outdoor
measurement data is displayed on
the base station.
• The measured value is automatically
updated by the base device about
every 45 seconds.
• If the temperature is outside of the
measuring range, LL.L (lower than
minimum temperature) or HH.H
(higher than maximum temperature)
will appear on the temperature
display.
6.2. Selecting the channel/Other
measuring stations
• You can connect up to three different
base stations to the measuring
station. Ensure that the base station
and measuring station are set to the
same channel. Suitable base stations
can be found at www.hama.com
• The transmission channel on the
supplied measuring station can be
changed/set (CH1, CH2, CH3).
• The measuring station is suitable for
the following base stations: 136222,
136293
8
Note