Hama 00136222 Bedienungsanleitung Seite 6

Alarm
• Repeatedly press the MODE button (22) to access alarm
mode.
• AL is displayed accordingly in the seconds display.
• Press and hold the MODE button (22) for approx. 3 seconds
to set the signal time of the alarm displayed. The hours
display begins to flash.
• Set the following information in the order listed:
• Hours
• Minutes
• To select individual values, press the UP button (23) or the
DOWN/MEM button (24) and confirm each selection by
pressing the MODE button (22).
• If you do not make an entry for 30 seconds, the device
automatically exits the settings mode and the settings you
made are saved.
• In the alarm mode (AL) display, press the UP button (23) or
the DOWN/MEM button (24) to activate or deactivate the
alarm. The alarm symbol (1) will appear/not appear.
• If the alarm is triggered, the alarm symbol (1) will begin to
flash and an alarm will sound.
• Press any button (except the SNZ/LIGHT button (27)) to
stop the alarm. Otherwise, it will stop automatically after
2 minutes.
Note – Snooze function
• While the alarm signal is sounding, press the SNZ/LIGHT
button (27) to activate the snooze function. Zz begins to
flash on the display. The alarm signal will be stopped for 5
minutes, after which it will sound again.
• Press any button (except the SNZ/LIGHT button (27)) to
stop the snooze function and the alarm.
6.4. Weather forecast/ atmospheric pressure history
• Based on changes in the atmospheric pressure and the data
saved, the base station is able to make weather forecasts for
the next 12 to 24 hours.
Note – Weather forecast
The weather forecast function is not available during the
first few hours of operation because it requires data that is
collected during operation.
• The weather forecast and the current weather are indicated
by five different symbols (4):
Symbol (2)
• The weather station indicates a trend as to how the values
6.5 Maximum and minimum temperature and humidity
values
• The base station automatically stores the maximum and
• Repeatedly press the DOWN/MEM button (24) to switch
• Press and hold the DOWN/MEM button (24) for approx. 3
• The maximum and minimum values are automatically deleted
6.6 Outdoor temperature alarm
• Repeatedly press the CH button (25) to select the measuring
Weather
• Press and hold the ALERT button (26) for approx. 3 seconds
Sunny
• The symbol for the lower limit value
for the outdoor temperature (8) and room temperature (5) are
likely to develop over the next few hours.
Display
minimum indoor/outdoor temperature and humidity values.
between the current temperature and humidity, minimum
temperature and humidity (MIN) and maximum temperature
and humidity (MAX).
seconds to reset the stored maximum and minimum values.
every day at midnight.
station channel (7) for which you would like to set an alarm.
until the outdoor temperature display (8) begins to flash.
limit value (8) flashes.
Slightly cloudy
Cloudy
Rainy
Trend
Increasing
Constant
Decreasing
is displayed and the
5