Siemens SIMATIC NET CP 5621 Betriebsanleitung Seite 29

Note
The product was tested in a device that also meets the standards listed above.
When operating the module in a device that does not meet these standards, there can be no
guarantee that the values will be achieved.
Declaration of conformity
The EC Declaration of Conformity is available for the responsible authorities according to the
above-mentioned EC Directive at the following address:
Siemens Aktiengesellschaft
Industry Sector
Industrial Communication (A&D SC IC)
Postfach 4848
D-90327 Nürnberg, Germany
Machinery directive
The products are not machines in the sense of the EC Machinery Directive. There is
therefore no declaration of conformity relating to the EC Machinery Directive 2006/42/EEC
for these products.
If the products are part of the equipment of a machine, they must be included in the
declaration of conformity procedure by the manufacturer of the machine.
Notice for Australia (C-TICK)
The product CP 5621 meets the requirements of the AS/NZS 3548 standard.
ICES conformity
The digital class B product CP 5621 fulfills the requirements of Canadian standard
ICES-003.
CSA approval
The SIMATIC NET product CP 5621 is approved in accordance with standard CAN/CSA C
22.2 no. 60950-1.
Notice for USA (FCC)
You will find this information in the English part of the document.
UL approval
The SIMATIC NET product CP 5621 is approved in accordance with standard UL 60950-1,
First Edition.
CP 5621
Operating Instructions (Compact), 02, A5E01156749
Approval, Certificates
13