Installation/Setup - Renkforce UHF-2032 Bedienungsanleitung

7. Installation/Setup

Ensure proper ventilation when setting up/installing the device.
Never place the receiver on any soft surfaces such as carpets, beds, etc.
In addition, air circulation must not be obstructed by any objects such as magazines, tableclo-
ths, curtains etc. This prevents heat removal from the product and can lead to overheating (risk
of fire).
Do not drill any holes or screws into the housing in order to attach the appliance somewhere,
this will damage it and even impair its safety.
Make sure that the device is set up securely positioned on a steady surface.
Persons can be injured if the receiver drops.
When setting up the device, make sure that the connection cables are not squeezed or damaged
by sharp edges.
Always install the cables so that nobody can trip over them or become entangled in them. Risk
of injury.
When selecting a place to set up the device, avoid direct, intense sunlight, vibration, dust, heat,
cold and moisture.
Make sure there are no devices with strong electric or magnetic fields such as transformers,
motors, cordless telephones or radio-controlled devices in the direct vicinity, because they can
cause interferences in the device.
The radio microphone set can also be influenced by interference (radiation) through tuners, TV
sets etc. Keep as great a distance as possible to such devices.
Even metal surfaces, reinforced concrete walls etc. in the frequency range may lower the range
of transmission.
Never place the device on valuable or sensitive furniture surfaces without sufficient protection.
• Place the device on an even surface.
• If necessary, the device can be attached, e.g. to a worktop or a rack by the drill holes in the front pa-
nel.
25