Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
STARTING OPERATION
Install the device on a plane surface.
The liquid tank of the device needs to be filled with bubble liquid before starting up operation and always
disconnected from the mains as fluid could be spilled.
If fluid should get into the interior of the device, disconnect from mains immediately and consult a technician.
Rigging
Install the device out of the public area. Please consider that liquid may be spilt during operation around the
device. The resulting slippery surface can cause accidents.
Only install the machine on scratch resistant and water resistant surfaces.
Please make sure that the inclination angle does not exceed 15°.
This device is constructed for a standing installation only. If the device is to be installed overhead, the
following safety instructions are binding:
Please consider the
installation! The installation must only be carried out by an authorized dealer!
When rigging, derigging or servicing the device staying in the area below the installation place, on bridges,
under high working places and other endangered areas is forbidden.
The operator has to make sure that safety-relating and machine-technical installations are approved by an
expert before taking into operation for the first time and after changes before taking into operation another
time.
The operator has to make sure that safety-relating and machine-technical installations are approved by an
expert after every four year in the course of an acceptance test.
The operator has to make sure that safety-relating and machine-technical installations are approved by a
skilled person once a year.
Procedure:
The device should be installed outside areas where persons may walk by or be seated.
The device has to be installed out of the reach of people.
For overhead use, always install a safety-rope that can hold at least 12 times the weight of the device. You
must only use safety-ropes with quick link with screw cap. Pull the safety-rope through the attachment eyelet
on the rear panel of the device and over the trussing system or a safe fixation spot. Insert the end in the
quick link and tighten the safety screw.
The maximum drop distance must never exceed 20 cm.
A safety rope which already hold the strain of a crash or which is defective must not be used again.
Before taking into operation for the first time, the installation has to be approved by an expert!
DANGER TO LIFE!
EN 60335-1:1996 a
nd the respective national norms during the
DANGER TO LIFE!
13/27
51705138_V_1_1.DOC
Werbung
Inhaltsverzeichnis
