Ensure a secure base. Make sure the appliance has a firm and secure base when setting
it up.
Avoid contact with hot parts. Do not touch hot parts on the appliance. Note that various
components can store heat and can therefore also cause burns after use of the appliance.
Look out for damage. Check the appliance for any signs of damage before putting it
into operation. If defects are apparent on the appliance, it must not be put into operation
on any account.
Do not use sharp objects. Never insert sharp and/or metallic objects inside the
GB
appliance.
Do not misuse. Do not use the appliance for purposes other than those intended in these
operating instructions.
Check regularly. Use of this appliance can cause certain parts to become worn. Therefore
check the appliance regularly for signs of damage and defects.
Check power cord. Do not use the appliance if the power cord shows is damaged. It is
imperative to contact the ROWI Service Centre in the event of damage.
Do not use power cords for other purposes. Do not pull the appliance at the cable
and do not use it to pull the plug out of the socket. Protect the cable from heat, oil and sharp
edges.
Only use original accessories. For your own safety, only use accessories and addi-
tional devices that are expressly recommended in the operating instructions or by the
manufacturer.
Do not use in explosive zones. Do not use the appliance in an explosive environment
containing substances such as flammable liquids, gases and especially spray and dust mist.
These substances can ignite due to hot surfaces on the appliance.
Pull out power plug. Pull the power plug out of the socket when not using the appliance
and before all maintenance work.
1.7.2 Specific safety notes
P Never use this appliance in the immediate vicinity of a bath, shower or swimming pool.
P Make sure the appliance has a secure and stable base when setting it up. Only use the
appliance in an upright position. If the appliance has tipped over, pull out the power
plug, return the appliance to an upright position and allow to cool down before putting
it into operation again.
26/40