Installation - AEG 47036IU Benutzerhandbuch

INSTALLATION

WARNING!
Refer to "Safety information"
chapter.
TECHNICAL DATA
Height
Width
Depth
Oven capacity
Voltage
Frequency
LOCATION OF THE
APPLIANCE
You can install your freestanding appli-
ance with cabinets on one or two sides
and in the corner.
Minimum distances
Dimen-
sion
A
B
LEVELLING
Use small feet on the bottom of appliance
to set the appliance top surface level with
other surfaces.
Dimensions
847 - 867 mm
596 mm
600 mm
74 l
230 V
50 Hz
B
A
A
mm
2
685
ANTI-TILT PROTECTION
CAUTION!
You must install the anti-tilt pro-
tection. If you do not install it, the
appliance can tilt.
Make sure you install the anti-tilt
protection at the correct height.
1. Set the correct height and area for
the appliance before you attach the
anti-tilt protection.
2. Install the anti-tilt protection 77 mm
down from the top surface of the ap-
pliance and 49 mm from the left side
of the appliance into the circular hole
on a bracket (see fig.). Screw it into
the solid material or use applicable
reinforcement (wall).
3. You can find the hole on the left side
on the back of the appliance (see
fig.).
Lift the front of the appliance (1) and
put it in the middle of the space be-
tween the cupboards (2). If the space
between the bench cupboards is larg-
er than the width of the appliance,
you must adjust the side measure-
ment to centre the appliance.
Make sure that the surface behind the
appliance is smooth.
ENGLISH
37