Replacing The Fuse; Technical Specifications - EuroLite LED PD-1 Bedienungsanleitung

Replacing the fuse

If the fine-wire fuse of the device fuses, only replace the fuse by a fuse of same type and rating.
Before replacing the fuse, unplug mains lead.
Procedure:
Step 1: Unscrew the fuseholder on the rearpanel with a fitting screwdriver from the housing (anti-
clockwise).
Step 2: Remove the old fuse from the fuseholder.
Step 3: Install the new fuse in the fuseholder.
Step 4: Replace the fuseholder in the housing and fix it.
Should you need any spare parts, please use genuine parts.
If the power supply cable of this device becomes damaged, it has to be replaced by authorized dealers only
in order to avoid hazards.
Should you have further questions, please contact your dealer.

TECHNICAL SPECIFICATIONS

Power supply:
Power consumption:
DMX-control-channels:
DMX-512-connection:
Sound-control:
Number of LEDs:
Dimensions (LxWxH):
Weight:
Maximum ambient temperature T
Maximum housing temperature T
Min. distance from flammable surfaces:
Min. distance to lighted object:
Fuse:
Accessory:
FUTURELIGHT EX-6/32 controller
FUTURELIGHT CP-240 controller
FUTURELIGHT CP-512/64 controller 16bit
EUROLITE DMX operator 192 channels
EUROLITE DMX scan control 192 channels
Wizard-512 USB DMX software + interface
Wizard-1024 USB DMX software + interface
FUTURELIGHT DES-3 DMX-terminator 3-pin
Please note: Every information is subject to change without prior notice. 01.07.2008 ©
230 V AC, 50 Hz ~
15 W
4
3-pin XLR
via built-in microphone
57
445 x 245 x 195 mm
2.5 kg
: 45° C
a
(steady state): 50° C
B
0.5 m
0.1 m
F 0.5 A, 250 V
No. 51834046
No. 51834265
No. 51834295
No. 70064520
No. 70064525
No. 51860102
No. 51860110
No. 51834001
20/20 00038069.DOC, Version 1.0