Electrical Safety; Important Additional Safety Instructions; Fcc Compliance Statement - Medion MD 31119 Bedienungsanleitung

Electrical Safety

Safety of information technology equipment.
EN 60950
•
The connection of devices is limited to equipment that complies with EN60950 "Safety of information
technology equipment" or EN60065 "Audio, video and similar electronic apparatus. Safety requirements"
•
For U.S. / Canadian purposes: The PC should only be connected to equipment which complies with UL
60950 / CAN CSA 22.2 No 60950

Important Additional Safety Instructions

When using any electronic equipment, basic safety precautions should always be taken. Following the guidelines
below can reduce the risk of fire, electric shock and injury to person:
•
Do not use this product near water (e.g., near a bathtub, wash bowl, kitchen sink or laundry tub, in a wet
basement or near a swimming pool).
•
Avoid using a telephone/modem (other than a cordless type) during an electrical storm. There may be a
remote risk of electric shock from lightning.
•
Do not use the telephone/modem to report a gas leak in the vicinity of the leak.
•
Use only the power cord indicated in this manual. Do not dispose of batteries in a fire. They may explode.
Check with local codes for possible special disposal instructions.
•
Keep batteries away from children at all times.

FCC Compliance Statement

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part
15 of FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
•
Consult the dealer or an experienced technician for help.
Changes or modifications not expressly approved by the party responsible for compliance could void the user's
authority to operate the equipment. Shielded interface cables, if any, must be used in order to comply with the
emission limits.
Safety and Precautions
5