Safety And Precautions; Operating Safety; Point Of Use; Repair - Medion MD 31119 Bedienungsanleitung

Safety and Precautions

Operating Safety

•
Do not allow children to play unattended on electrical equipment. Children may not always correctly
recognize danger.
•
Keep the packing materials, such as foil away from children. The danger of suffocation could arise in
the case of misuse.
•
Never open the housing of the TFT monitor (electric shock, short-circuit and the danger of fire)!
•
Do not insert any objects through the slots and openings into the inside of the TFT (electrical shock,
short-circuit and the danger of fire)!
•
Slots and openings in the TFT monitor are for ventilation purpose. Do not cover these openings, as
otherwise this may lead to overheating (overheating, danger of fire)!
•
Never exert pressure on the display. This could break the monitor.
•
An injury hazard exists when the display breaks. Wear protective gloves to pack the broken parts and send
them into your service center for proper disposal. Then wash your hands with soap, because it is possible
for chemicals to escape.
•
Do not touch the display with your fingers or with sharp objects to avoid damage.
Please proceed as outlined in the Customer Service section:
•
if the power cable overheats or is damaged
•
if liquid has gotten into the monitor
•
if the TFT monitor is dropped or the housing damaged

Point of use

•
In the first hours of operation, new devices may emit a typical, unavoidable but completely harmless smell,
which will decline increasingly in the course of time.
We recommend you to ventilate the room regularly, in order to counteract the formation of the smell.
During the development of this product, we have made sure that the applicable limits are clearly fallen
below.
•
Keep your TFT monitor and all units connected to it away from moisture and avoid dust, heat and direct
sunlight. Failure to observe these instructions can lead to malfunctions or damage to the TFT monitor.
•
Do not operate your device in the open air, because external influences, such as rain, snow, etc. could
damage the device.
•
Do not place any containers filled with liquid (vases or similar containers) on the device. The
container could tip over and liquid can impair electrical safety.
•
Do not place any open sources of fire (candles or similar objects) on the device.
•
Pay attention to sufficiently large clearances in the wall cupboard. Maintain a minimum clearance
of 10 cm around the device for sufficient ventilation.
•
Place and operate all units on a stable, level and vibration-free surface in order to avoid the TFT
monitor from falling.
•
Avoid dazzle, reflections, extreme light/dark contrast in order to save your eyes and
ensure a pleasant, ergonometric work station.
•
Take regulator breaks when working with your TFT monitor in order to avoid tension and
fatigue.

Repair

•
Leave all repairs of your TFT monitor to authorized and qualified personnel only.
•
Should a repair be necessary, please contact one of our authorized service partners only.
Safety and Precautions
3