Intended Environment; Power Supply; Standards/Electro-Magnetic Compatibility; Ergonomics - Medion MD 31119 Bedienungsanleitung

Intended Environment

•
The TFT monitor can be operated at an ambient temperatures of between +41°F and +95°F
(5° C to 35° C) and at a relative humidity of between 20% and 85% (without condensation).
•
When switched off, the monitor can be stored at between -4°F and +140°F (-20° C - +60° C), up to the
maximum height of 39,000 ft (12,000 m) above sea level at a relative humidity of between 20% and 80%
(without condensation).
•
After transporting your TFT monitor please wait until it has assumed the ambient temperature before
connecting and switching it on. Extremely high variations in the temperature or humidity may result in
condensation forming on the inside of the TFT monitor which could cause an electrical short-circuit.

Power Supply

Please pay attention: Pats of the device are still live, even if the mains switch is switched off. Pull
the mains plug out of the socket, to interrupt the power supply to your TFT monitor or to release
the device from voltage completely.
•
Operate your TFT monitor mains (power supply) only on grounded sockets with 100-240V~/ 50-60 Hz.
If you are not sure about the power supply at your location, check with your power company.
•
For additional safety we recommend use of an excessive voltage protection device to protect your TFT
monitor from damage resulting from voltage surges or lightning.
•
To interrupt the TFT monitor from mains (power supply) disconnect the plug from the socket.
•
To avoid power consumption when the device is switched off either pull out the power plug when the
device is not used or connect the device to a master-/slave power bar.
•
The power socket must be in the vicinity of your TFT monitor and within reach of the power cables. DO
NOT stretch the power cables tightly to reach a power socket.
•
If you use an extension cable, ensure that it fulfills the VDE requirements. Please ask your
electrician.
•
You should lay the TFT Monitor cables in a manner that no one can trip or step on it.
•
To avoid damage of cable do not place any objects or furniture on the cable.
•
Use a master/slave power strip to avoid consuming electricity when the equipment has been switched off.

Standards/Electro-Magnetic Compatibility

Your monitor fulfils the requirements for electro-magnetic compatibility and electrical safety specified in the
following standards:
•
When connecting ensure that Guidelines for Electro-Magnetic Compatibility (EMC) are observed.
•
Provide an interval of at least one meter from high-frequency and magnetic sources of interference
(television sets, loudspeakers, mobile telephones, etc.) in order to avoid malfunctions and data loss.

Ergonomics

•
This monitor complies with all relevant regulations such as DIN EN ISO 9241-3, DIN EN ISO 9241-7 and DIN
EN ISO 9241-8.
•
For ergonomic reasons we suggest not to use the base-color blue on dark subfonds. This would cause bad
readability and would increase eye strain.
•
While working with screens you should take breaks periodically to avoid tension and fatigue.
•
In order to save your eyes and to assure a convenient working area you should avoid glare, reflections
and strong contrasts on the screen. For more detailed information on workplace ergonomics, see page 11.
4
EN 55022, EN 55024, EN 60950, EN 61000-3-2, EN 61000-3-3
UL60950 / CAN CSA 22.2 No 60950, FCC
English