HEYLO FT 1000 Bedienungsanleitung Seite 22

After use: After every refurbishment use FT 1000 has to be cleaned thoroughly before taking it out of
the refurbishment area. For transport from a contaminated area, the unit can be closed with a sealing
cover so that the contamination cannot be passed only (see optional equipment).
This is done by using a safety vacuum cleaner and by moist wiping. Compressed air is not permitted
here. The area around the air intake has to be observed especially.
ATTENTION: Let the unit dry before fitting a new filter !
Change of filter indicator: When the signal is sounded, the pre-filter has to be replaced and the main
filter has to be vacuumed (if the type of dust is not known, use safety vacuum cleaner of dust class H)
wearing personal protection equipment. Please remember to have sufficient filter material available in
order to prevent interruption of the work.
ATTENTION: Before changing the filter, put the unit out of service !
Please refer to the following table to determine which filter class is required for which material:
Material
Hausstaub
Erde
Sand
Styropor
Buche
Eiche
Esche
Kiefer
Tanne
Birke
Gips
Zement
Ziegel
Bims
Kalksandstein
Pre-filter: The first filter stage consists of three Z line pre-filters. The pre-filters are pushed into the
filter cassette. To change the pre-filter, the filter cassette has to be pushed up by abt. 1 cm. Now the
filter cassette can be removed from the front and the new pre-filter can be pushed in. Subsequently
place the filter cassette in the unit again.
Klasse M Klasse H Material
X Porenbeton
X Betonstaub
X Zementestrich
X Fliesenkleber
Latex- und Ölfarben
X
Bleihaltige Lacke
X
Kalkputz
X
Kalkzementputz
X
Zementputz
X
X Lehmputz
X Gipsputz
X Schimmelpilzsporen
X Asbest (BGI 664)
X Mineralfasern
Krebserregende Stoffe
X
Klasse M
22
Klasse H
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
EN