Cleaning The Shaver Under The Tap - Philips HQ789 Bedienungsanleitung

EnglisH
12
1 Simultaneously press the buttons on both sides of the Jet Clean
system (1) and lift the Jet Clean system off the cleaning chamber
(2). (Fig. 20)
The cleaning chamber remains behind.
2 Pour any remaining cleaning fluid out of the cleaning
chamber. (Fig. 21)
You can simply pour the cleaning fluid down the sink.
3 Rinse the cleaning chamber under the tap (Fig. 22).
4 Place the Jet Clean system back onto the cleaning chamber (Fig. 23).
Make sure the release buttons snap back into place.
5 Clean the Jet Clean system with a moist cloth.

cleaning the shaver under the tap

Be careful with hot water. Always check if the water is not too hot, to
prevent your hands from getting burnt.
1 Switch off the shaver, remove the adapter from the wall socket and
pull the appliance plug out of the shaver.
2 Press the release button to open the shaving unit (Fig. 24).
3 Rinse the hair chamber and the inside of the shaving unit under a
hot tap for some time (Fig. 25).
4 Rinse the outside of the shaving unit under a hot tap for some
time (Fig. 26).
5 Close the shaving unit and shake off excess water.
Never dry the shaving unit with a towel or tissue, as this may damage
the shaving heads.
6 Open the shaving unit again and leave it open to let the shaver dry
completely (Fig. 27).
You can also clean the hair chamber without water with the brush supplied.