Before Use; Unpacking; Selecting The Proper Nozzle; Assembly - Dirt Devil M7017 Mustang irl Y50 Bedienungsanleitung

3 Before use

3.1 Unpacking

3 Before use
ATTENTION:
Always transport or ship the appliance in its original packaging to avoid
damage.
Keep the packaging for such an event.
However, dispose of no longer needed packaging material properly.

3.2 Selecting the proper nozzle

1
2
1
2
3

3.3 Assembly

A
1
4
A
5
12
4
2*
3*
A B
B
1
B C
1. Unpack the appliance and all its accessories.
2. Check that the contents are intact (Fig. 1).
NOTE:
Immediately contact your dealer if you have found damage resulting
from transport.
1. Select the nozzle according to the surface to be cleaned:
5
„
As well as the floor nozzle (Fig. 2/1), the upholstery nozzle (Fig. 2/4)
and the 2-in-1 combi brush (Fig. 2/5) are included as accessories in the
scope of delivery.
- Upholstery nozzle (Fig. 2/4): Use this to vacuum up dust off uphol-
stered furniture.
- The 2-in-1 combi brush (Fig. 3/A) can be used as a:
- Crevice nozzle (Fig. 3/A1): Use this to vacuum dust from hard-to-
reach places.
- Furniture brush (Fig. 3/A2): Use this to vacuum dust off objects that
have sensitive surfaces.
„
*Optionally available (i. e. included in the scope of delivery depending
on model and features) are also:
- Parquet brush (Fig. 2/2*)
Its long bristles make it especially suitable for cleaning delicate sur-
faces (e.g. parquet and laminate floors).
- Turbo brush (Fig. 2/3*)
This has a rotating brush head and is most suitable for thoroughly
deep cleaning carpets. The brushing also raises the carpet pile.
2. Push nozzles not in use onto the stubs of the accessory bracket (Fig. 3/
B).
3. Keep the other nozzles safe and inaccessible to children.
WARNING:
Danger of injury! Only attach the nozzles if the appliance is not con-
nected to the power supply. The cylinder vacuum cleaner could be
switched on by accident.
ATTENTION:
Before vacuuming, make sure that the fitted nozzle suits the surface to
be cleaned. Also observe the flooring manufacturer's recommendations.
1. Attach the selected nozzle to the bottom end of the telescopic tube
(Fig. 4/A1) or of the handle (Fig. 4/B1).
2. Insert the end of the suction hose into the intake opening (Fig. 5/A) of
the vacuum cleaner until you hear and feel it locking into place.
If using the telescopic tube:
3. Insert the handle into the upper end of the telescopic tube (Fig. 5/B).
4. Adjust the length of the telescopic tube (Fig. 5/C). Press down the re-
lease latch on the tube to do this. Then extend the telescopic tube to
the desired length. Let go of the release catch while pulling until it locks
in place. You will hear a distinct click.