Trouble Shooting; Ce Mark And Ec Conformity - Superrollo TA70 . Bedienungsanleitung

i
Trouble shooting
Error
The door operator does not work.
The hand transmitter cannot actuate
the door operator.
The operating range of the hand
transmitter is too restricted.
The chain moves, but the door does
not.
When operating, a grating sound can
be heard.
The chain has some sag and is noisy.
i
CE Mark and EC Comformity
The garage door opener of series TA70 (Item no. SR40070) inclusive Hand transmitter, complies with the requirements of the
current European and national directives.
Conformity has been verified. The corresponding declarations and documentation are available on file at the manufacturer's premises.
superrollo Hausautomatisierung GmbH
Gewerbepark 1
01156 Dresden
Germany
66
Causes
1. The plug is not inserted properly.
2. The fuse has been tripped.
1. The hand transmitter may have
been wrongly registered or has not
been registered at all.
2. The battery is out of power.
The battery may be empty.
The emergency release may have
been triggered.
There is not sufficient lubricant bet-
ween the rail and the chain slide after
long use.
The chain is loose due to long use
without lubricant between the rail and
the chain slide.
2006/95/EC Low-voltage directive
2006/42/EC Machinery directive
2004/108/EC EMC directive
1999/5/EC R&TTE directive
Solution
1. Plug the mains plug into the mains
outlet.
2. Have the cause checked by a quali-
fied person, then switch the fuse
back on again.
1. Register the hand transmitter
again, refer to page 60.
2. Replace the battery
Replace with a new one of the same
model.
Operate the door operator until the
emergency release engages again
automatically.
Insert a suitable lubricant in the position
between the rail and the chain slide.
Tension the chain as described on
page 46 and apply a suitable lubricant
to the chain.
EN