Trouble Shooting; Ce Mark And Ec Comformity - Superrollo SR40070 Betriebsanleitung

i

Trouble shooting

Error
The door operator does not work.
The hand transmitter cannot actuate
the door operator.
The operating range of the hand
transmitter is too restricted.
The chain moves, but the door does
not.
When operating, a grating sound can
be heard.
The chain has some sag and is noisy.
i

CE Mark and EC Comformity

The garage door opener of series TA70 (Item no. SR40070) inclusive Hand transmitter, complies with the requirements of the
current European and national directives.
Conformity has been verified. The corresponding declarations and documentation are available on file at the manufacturer's premises.
superrollo Hausautomatisierung GmbH
Gewerbepark 1
01156 Dresden
Germany
Causes
1. The plug is not inserted properly.
2. The fuse has been tripped.
1. The hand transmitter may have
been wrongly registered or has not
been registered at all.
2. The battery is out of power.
The battery may be empty.
The emergency release may have
been triggered.
There is not sufficient lubricant be-
tween the rail and the chain slide
after long use.
The chain is loose due to long use
without lubricant between the rail and
the chain slide.
2006/42/EC Machinery directive
1999/5/EC R&TTE directive
Solution
1. Plug the mains plug into the mains
outlet.
2. Have the cause checked by a quali-
fied person, then switch the fuse
back on again.
1. Register the hand transmitter
again, refer to page 57.
2. Replace the battery
Replace with a new one of the same
model.
Operate the door operator until the
emergency release engages again
automatically.
Insert a suitable lubricant in the position
between the rail and the chain slide.
Tension the chain as described on page
44 and apply a suitable lubricant to
the chain.
EN
63