Connecting Additional Electrical Equipment - Superrollo TA70 . Bedienungsanleitung

i
Connecting additional electrical equipment
When working on electrical systems there is
a risk of danger to life due to electrocution.
◆ The connection of additional electrical equipment
must only be carried out by a qualified electrician.
◆ Before opening the protective cover always dis-
connect the equipment from the mains power supply
and check that the system is free of voltage.
Accessories from other manufacturers may
result in malfunctions or damage to property.
◆ Use only original accessories. A separate source
voltage at the screwtype terminal for the external
switch will result in a short circuit and will destroy
the door operator's electronics.
◆ Do not connect any separate source voltages to the
terminal for the external switch. The terminals are
potential-free contacts.
2
Key
1
= Motherboard
2
= Infrared-photocell barrier (optional)
3 = External switch (optional)
3
Ext. switch (type: NO)
GND
Pass Door contact
NOTE: If pass door contact assembled, remove jumper
GND IR + 12V
If the external buttons are not connected
properly, the operational safety of the
equipment is at risk.
Always mount the internal button, programming
button, etc.:
◆ outside the reach of movable parts
◆ within visibility of the door
◆ at a height of at least 1.5 metres
1
Connecting conditions for connecting an
infrared photocell barrier:
Voltage: = + 12 V
Curent: = max. 150 mA
Type: = NC
EN
61