Functional Description - Superrollo TA70 . Bedienungsanleitung

i
Functional description
Intelligent microcomputer
Intelligent, computerized, exact positioning of travel,
prompt power determination, reverses if obstructions
are met.
Door operator
Low noise, soft start and soft stop protect the motor
and ensure a long service life.
Self diagnosis
Operational mode and digital menu shown on the
display, self diagnosis.(L-Normal, F-Interrupted, H-Fail
In Reading, A-Infrared Ray Interrupted)
Cryptoguard
Rolling code technology provides billions of code combi-
nations and makes every remote control a unique one
that protects against unauthorized access.
Alarm unit
The alarm sounds when the door is left open for longer
than 10 minutes. The alarm stops when the door is
closed again (refer to „Alarm setting" on page 57).
i
Functional description / Recognition of obstructions
The door operator has an automatic obstacle-recognition
system (through internal monitoring of power).
If the door encounters an obstruction when closing or
opening, the door operator stops the door automatically
and moves it in the opposite direction until it reaches
the corresponding limit.
After removing the obstruction you can operate the
garage door operator normally again.
42
Emergency release device
The door can be manually operated by pulling down
on the emergency release cable in the case of power
failure.
Automatic closing function
The automatic closing time of the door can be set from
30 to 240 seconds (refer to page 57/58).
2000 cycle alarm
When the operator has run 2000 cycles, it will beep
to remind the user to service the mechanical system
(refer to page 58).
Lighting
The TA70 garage door operator has internal lighting which
is switched on after each switching impulse and goes off
again automatically after 3 minutes.
Additional connecting options for external
accessories and safety unit
In addition you can connect an external switch and an
infrared photoelectric barrier (refer to page 61).
EN