Assembly Of The Rails; Tension The Drive Chain - Superrollo TA70 . Bedienungsanleitung

Assembly of the rails
NOTE
The TA50 is supplied with three rails:
◆ two end pieces, including a pre-assembled chain.
◆ a middle piece (without a chain) with two connectors.
1. Lay the two end pieces with the pre-
assembled chain on the ground, with the
chain lying as straight as possible between
the two end pieces.
Push the two enclosed connectors onto the
2.
middle piece and then lay the middle piece in
the gap between the two end pieces.
3. Insert the chain into the middle piece.
Push each of the connectors onto the join
4.
between the middle piece and each of the
end pieces.
Please ensure that each of the connectors lies in the
centre between the fixing plates of the rail underside.
5. Finally, bend the fixing plates outwards with
a small screwdriver.
As a result, the connectors can no longer be moved.
Tension the drive chain
1. Screw the clamping nut tight with a suitable
socket key (∅ 10 mm).
2. Adjust the tension of the chain as shown in
the picture.
ATTENTION:
Due to manufactoring tolerances, the shown
range of approx. 37-41 mm can vary.
Make shure that the chain sags a little on the
full length of the rail, so that it is not streched
too tight. Otherwise it can result in a loss of
power the drive.
46
Connector 1
1.
2.
EN
Connector 2
Fixing plates
1
2
3