Installation; Appropriate Installation Location; Removing The Transportation Safety Assembly - Grundig GTN 37110 G Bedienungsanleitung

Installation

3
Refer to the nearest Authorized Service Agent
for installation of the product. To make the
product ready for use, make sure that the
electricity and water drainage systems are
appropriate by reading the information/
instructions given in the user manual before
calling the Authorized Service Agent. If
they are not, call a qualified technician and
plumber to have any necessary arrangements
carried out.
C
Preparation of the product's location
as well as the electrical, clean water
and waste water installations is under
customer's responsibility.
B
CAUTION: Installation and electrical
connections of the product must be
performed by the Authorized Service
Agent. Manufacturer shall not be
held liable for damages that may
arise from procedures carried out by
unauthorized persons.
A
CAUTION: Prior to installation,
visually check if the product has any
defects on it. If so, do not have it
installed. Damaged products cause
risks for your safety.
3.1 Appropriate installation
location
Install the product on a stable and level
ƒ
surface.
ƒ Dryer is heavy. Do not move it by yourself.
ƒ Operate your product in a well ventilated,
dust-free environment.
Do not block the air ducts in front of and
ƒ
under the product with materials such as
long pile rugs, wooden blocks and bands.
ƒ Do not install the product behind a door
with a lock, sliding door or a hinged door
which can strike the product.
Once the product is installed, it should
ƒ
stay at the same place where its
connections have been made. When
installing the product, make sure that the
rear wall of it does not touch anywhere
38 / 60 EN
(tap, socket, etc.). Also pay attention to
select an installation location which you
will not be required to change afterwards.
Place the product at least 1.5 cm away
ƒ
from the edges of other furniture.
B
CAUTION:
product on top of the power cord.
3.2 Removing the
transportation safety assembly
A
CAUTION: Remove the
transportation safety assembly before
using the product for the first time.
1. Open the loading door.
2. There is a nylon bag inside the drum that
contains a piece of styrofoam. Hold it
from its section marked with XX XX.
3. Pull the nylon towards yourself and
remove the transportation safety
assembly.
A
CAUTION:
the transportation safety assembly
remains inside the drum.
Do not place the
Check that no part of
Dryer / User Manual