Trouble-Shooting Guide - NEFF E 1461 Gebrauchsanweisung

Calling the customer service is not always really necessary. In some cases, you can remedy the situation your-
self. The following table may contain some helpful tips.
Important general safety guidelines:
Service or repair work on the electronic components may only be performed by a qualified expert. Without exception, prior
to starting such repairs, the appliance must be disconnected from the mains. This may be accomplished by tripping the
automatic fuse or by removing the fuse from the fuse box that controls your flat or apartment.
Problem
There is a general failure of all electri-
cal functions, i.e., the control lamps
have suddenly ceased to function.
Liquids or thin viscous dough are
distributed at a visibly uneven thick-
ness.
The oven cleaning control lamp fails
to illuminate after the function has
been activated?
The oven door window pane fogs
up.
A considerable amount of water
condensation occurs in the oven.
... if enamelled slide-in parts have
dull, light blotches?
... if after prolonged use, the oven
window panes are soiled from the
inside.
50

Trouble-shooting Guide

Possible cause
Defective fuse.
The appliance has not been placed
or installed plumb-and-level.
Temperature inside oven cavity is still
too high, i.e., after prolonged use of
the hotplates.
Defective control lamp.
This is a normal condition. It is cau-
sed by the occurrence of temperatu-
re differences.
This condition is normal with cakes
having very moist toppings (fruit), or
with very large roasts.
Normal occurrence due to dripping
meat juices.
This kind of soiling is normal.
Remedy
Check teh fuse in the fuse box, and
replace if required.
Level the appliance using the level-
ling feet, or check the installation.
Prior to using the oven cleaning fun-
ction, the oven must be allowed to
cool completely.
Replacement only by an authorised
expert.
Heat the oven at 100° C for about 5
minutes.
During baking or roasting, open the
oven briefly several times; wipe up
condensation after use.
Not possible.
Detach the oven door and lay front
side down on a soft, clean base.
Grip the door glass near the hinges,
pull up and remove.
Doors with 3 panels:
Disengage inner door glass at the
corner pieces and lift it up using, for
example, a pair of frying tongs made
of plastic or wood.
Installing the cleaned glass:
Insert the inner door glass and lock
into position.
Attach the door glass and lock into
position by pressing the glass near
the hinges.