Pioneer AVH-P5100DVD Installationsanleitung Seite 7

Wired remote input
Hard-wired remote control adaptor
can be connected (sold separately).
IP-BUS cable
IP-BUS input
(Blue)
Yellow/black
If you use an equipment with Mute function, wire this lead to the Audio Mute lead on
that piece of equipment. If not, keep the Audio Mute lead free of any connections.
Connection method
1. Clamp the lead.
Note:
• The position of the parking brake switch depends on the vehicle model. For details,
consult the vehicle Owner's Manual or dealer.
Light green
Used to detect the ON/OFF status of the parking brake. This
lead must be connected to the power supply side of the parking
brake switch.
Blue/white
Connect to system control terminal of the power
amp (max. 300 mA 12 V DC).
Blue/white (6*)
The pin position of the ISO
connector will differ depending
on the type of vehicle. Connect
6* and 7* when Pin 5 is an
antenna control type. In other
types of vehicles, never connect
6* and 7*.
Interface cable (e.g., CD-IU205V)
(sold separately)
Multi-CD player
(sold separately)
Blue/white (7*)
Connect to auto-antenna relay control terminal
(max. 300 mA 12 V DC).
Notes:
• Change the initial setting of this unit (refer to the Operation
Manual). The subwoofer output of this unit is monaural.
• When using a subwoofer of 70 W (2 Ω) , be sure to connect with
Violet and Violet/black leads of this unit. Do not connect
anything to Green and Green/black leads.
80 cm
Power supply side
Ground side
Dock connector
Connect to separately sold iPod.
80 cm
Tuner box (supplied)
Antenna cable
(supplied)
2. Clamp firmly with
needle-nosed pliers.
Parking brake
switch
6