Important Safeguards - Alpina SF 7642 Bedienungshinweise

When using electrical appliances, basic safety precautions should be followed:
1. Read all instructions carefully.
2. Make sure the power supply corresponds to one on the rating label.
3. To avoid electrical shock, do not immerse electrical parts in water or other liquid.
4. Do not allow children to operate or play with the appliance.
5. Unplug from outlet when not in use, or before putting on/taking off parts.
6. Do not use with damaged electrical cord or plug.
7. If damaged or malfunction occurs, refer to an authorized service center only.
8. Do not place on or near hot surfaces.
9. Never pull the appliance by the power cord.
10. Do not use the appliance for other than intended household use.
This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental
capabilities or lack of experience and knowledge, unless they have been given supervision or instruction by a person
who is responsible for their safety concerning the use of the appliance. Children should be supervised to ensure that
they do not play with the appliance.
Parts Description
1. Control panel
2. Switch button
3. Front housing
4. Halogen tube heating
element
5. Reflector/Radiator
6. Base
7. T ip‐over switch
Save these instructions:
1. Remove the packaging material such as bags, staples, stickers and make sure that the appliance is intact.
2. The appliance has to be connected to a circuit according to the rules in force concerning the civil plant. The plant
has to be related to the nominal power of the appliance and has to be provided with an earth –wire.
3. When unit is used at high temperature, make sure there is nothing flammable or easy deform object
within 1 meter in front of the unit and about 0.5 meter at the back of the unit, do not place in wet
surface.
4. Never touch the protector on front of the unit during operation to avoid burn.
5. Do not use this heater in the immediate surroundings of a bath, a shower or in a swimming pool.
Assembly: Assemble the body frame and the base plate together as the following sequences
1. Remove the butterfly nuts from the lower part of the body frame.
2. Insert the power cord through the slot placed in the middle part of the basement and then assemble the body
frame to the base plate.
3. Secure the body frame to the base plate by means of the two butterfly nuts previously removed. Insert the power
cord through the suitable slots and then fix it by the clamp
IMPORTANT SAFEGUARDS
2
ENGLISH