IKEA ISANDE Handbuch Seite 20

ENGLISH
Problem
The compressor does not
start immediately after
pressing the Fast Freezing,
or after changing the tem-
perature.
The compressor does not
start immediately after
pressing the Shopping, or
after changing the tempera-
ture.
Water flows inside the re-
frigerator.
Water flows on the floor.
Temperature cannot be set.
Temperature cannot be set.
DEMO appears on the dis-
play.
The temperature in the ap-
pliance is too low/too high.
Possible cause
This is normal, no error has
occurred.
This is normal, no error has
occurred.
The water outlet is clog-
ged.
Food products prevent
that water flows into the
water collector.
The melting water outlet is
not connected to the evap-
orative tray above the
compressor.
The Shopping function is
switched on.
The Fast Freezing function
is switched on.
The appliance is in demon-
stration mode.
The temperature regulator
is not set correctly.
Solution
The compressor starts after a
period of time.
The compressor starts after a
period of time.
Clean the water outlet.
Make sure that food products
do not touch the rear plate.
Attach the melting water outlet
to the evaporative tray.
Switch off Shopping manually,
or wait until the function resets
automatically to set the tem-
perature. Refer to " Shopping
function".
Switch off Fast Freezing man-
ually, or wait until the function
resets automatically to set the
temperature. Refer to "Fast
Freezing function".
Keep the Function pressed for
approximately 10 seconds un-
til a long sound is heard and
display shuts off for a short
time.
Set a higher/lower tempera-
ture.
20