Installation And Dismantling; Installation Diagram - auna MD-170-BT Anschluss- Und Anwendungshinweise

Numerical function buttons:
1/
When completed searching radio stations automatically, press this button to listen to available sta-
tions, press and hold the same button to save such stations manually; In the MP3 mode, press this
button to pause playback, and press the same button again to resume.
2/INT
When completed searching radio stations automatically, press this button to listen to available sta-
tions, press and hold the same button to save such stations manually; In the MP3 mode, press this
button to browse tracks, and press the same button again to quit.
3/RPT
When completed searching radio stations automatically, press this button to listen to available stations,
press and hold the same button to save such stations manually; In the MP3 mode, press this button to
enable the function of Single Repeat, and press the same button again to disable such function.
4/RDM
When completed searching radio stations automatically, press this button to listen to available sta-
tions, press and hold the same button to save such stations manually; In the MP3 mode, press this
button to enable the function of Shuffle, and meanwhile, you can use buttons like
select tracks randomly. Press the same button again to disable such function.
5/-10
When completed searching radio stations automatically, press this button to listen to available sta-
tions, press and hold the same button to save such stations manually; In the MP3 mode, press this
button to play back the first 10 tracks.
6/10+
When completed searching radio stations automatically, press this button to listen to available sta-
tions, press and hold the same button to save such stations manually; In the MP3 mode, press this
button to play back tracks more than 10.

Installation and Dismantling

Installation Diagram

Before installing the main part, place it according to the installation locations and then connect with
the corresponding speakers and power-supply; Do not fix the main part unless it performs well.
Install the main part.
Place the holder on the dashboard and then bend certain snap-
ping components by force; Connect with the power-supply
cable and speaker wires and then attach the fixing tag to the
automobile; Slide the main part into the holder and then tigh-
ten the nuts on the fixing tag.
Dismantle the main part
Following loosening those nuts on the fixing tag,
insert each dismantling key into the space on either
left or right to pull the main part out. Later on,
detach the power-supply cable and speaker wires
and then the antenna connector.
and to
14
14