Bluetooth Operations; Rds Operations - auna MD-170-BT Anschluss- Und Anwendungshinweise

Pair with cell phone
First of all, move a cell phone close enough to the said product and then turn on the Bluetooth device
in such cell phone. Search the said product (code: 0000) for match-up.
Dial via Bluetooth
Once connected, press the Mode button to switch to "BTREADY" mode. press
ber or directly dial via the numerical keypad on the remote-control (0~9) and then press
Receive calls via Bluetooth
Once connected, when there is an incoming call, press
control to receive such call. To change the call-receiving device, press and hold "2INT" on the front
panel to switch among the cell phone and the said product. When conversation is over, press
the front panel or on the remote-control.
Play back music via Bluetooth
Once connected, press the Mode button to switch to the Phone mode. Launch a kind of music play-
back software installed on the cell phone to play music. Under such circumstances, press
to select a previous or next track
AF (Alternative Frequency) function
When the player is turned on for the first time, the system enters RDS (AF) state automatically. To
listen to other channels, please turn off RDS (AF) first, and then scan the channels, or else other
channels will be unavailable.
REG (Regionale Erkennung) function
In any state, press the SEL button to enter REG OFF state, and then use the VOL knob to select
REG ON or REG OFF.
TA (Traffic Announcement) function
In any state, press the SEL button to enter TA OFF state, and then use the VOL knob to select TA ON
and play the traffic broadcast automatically.
TA (Traffic Announcement) Volume selection
In any state, press the SEL button to enter TA VOL state, and then use the VOL knob to adjust the
TA volume.
EON (Enhanced Other Networks) function
In any state, press the SEL button to enter EON state, and then use the VOL knob to select whether
display the information of other channels.
PTY (Programme Type) function
In any state, press and hold the SEL button to enter part PTY state, and press the SEL button again
when the PTY type shows to enter the other PTY state. Then, use the number buttons (1~6) to select
the PTY type (note: each number buttons contains three types).

Bluetooth Operations

RDS Operations

to call the last num-
on the front panel or
to call.
on the remote-
on
and
16
16