Setting Up Your D711; Welcome Screen; Set Date And Time Manually; Getting To Know Your Phone - Motorola D710 Bedienungsanleitung

D711_IFU_EN_for_EU.book Page 6 Friday, August 24, 2007 3:58 PM
BATTERY LOW WARNING
If the icon flashes in the display, you will need to recharge the handset before you can use it
again.
During charging, the icon will scroll in the display.
BATTERY PERFORMANCE
In ideal conditions, fully charged batteries should give about 10 hours talk time or 100 hours
standby time on a single charge.
Note that new batteries do not reach full capacity until they have been in normal use for several
days.
To keep your batteries in the best condition, leave the handset off the base for a few hours at a
time.
Running the batteries right down at least once a week will help them last as long as possible.
The charge capacity of rechargeable batteries will reduce with time as they wear out, giving the
handset less talk/standby time. Eventually they will need to be replaced.
After charging your handset for the first time, subsequent charging time is about 6–8 hours a day.
Batteries and handset may become warm during charging. This is normal.

Setting up your D711

Welcome screen

1. WELCOME is displayed and scrolls in different languages. Press
on the display.
u d m
2. Scroll or to your country and press . CONFIRM?
3. Press OK to confirm.
The handset and base will reset to load the correct settings. The standby screen is then
displayed and your phone is ready to use.
You can still make and receive calls without first selecting your country and network operator,
however the Welcome screen will re-appear until you have configured your phone country settings.
Date and time
Providing you have subscribed to your network's Caller Display service, the date and time is set
automatically for all handsets every time a call is received.
The date and time is recorded with each answering machine message you receive.
If you do not have a Caller Display service you can set the date and time manually.

Set date and time manually

m d m
1. Press and scroll to CLOCK/ALARM. Press . Display shows
2. Enter the date using the format DD/MM e.g. 04/ 08 for 4th August.
m
3. Press and enter the time using the 24 hour format HH:MM,
e.g. 14:45 for 2.45pm.
m >
4. Press to confirm or to return to standby.
Your D711 is now ready for use.
6

2. Getting to know your phone

Overview of your handset

m
. The country name is shown
is displayed.
m
DATE & TIME, then press .
Getting to know your phone