How To Activate The Rinse Aid Dispenser; Technical Information; Environment Concerns - Atag VA63111ST Benutzerinformation

28
Refer to 'HINTS AND TIPS' for other
possible causes.
How to activate the rinse aid
dispenser
1. Press the on/off button to activate the
appliance. Make sure that the appliance
is in setting mode, refer to "Setting and
starting a programme".
2. Press and hold, at the same time, but-
ton and button
dicators of buttons
and start to flash.
3. Press button
• The indicators of buttons
and go off.

TECHNICAL INFORMATION

Dimensions
Electrical connection
Water supply pressure
1)
Water supply
Capacity
Power consumption
1) Connect the water inlet hose to a water tap with a 3/4'' thread.
2) If the hot water comes from alternative sources of energy, (e.g. solar panels, aeolian energy), use the hot water
supply to decrease energy consumption.

ENVIRONMENT CONCERNS

Recycle the materials with the symbol
Put the packaging in applicable containers
to recycle it.
Help protect the environment and human
health and to recycle waste of electrical and
electronic appliances. Do not dispose
appliances marked with the symbol
until the in-
, ,
.
,
Width / Height / Depth (mm)
Refer to the rating plate.
Voltage
Frequency
Min. / max. (bar / MPa)
Cold water or hot water
Place settings
Left-on mode
Off-mode
.
with
• The indicator of button
ues to flash.
• The display shows the current setting.
Rinse aid dispenser off.
Rinse aid dispenser on.
4. Press button
ting.
5. Press the on/off button to deactivate the
appliance and to confirm the setting.
6. Adjust the released quantity of rinse aid.
7. Fill the rinse aid dispenser.
2)
the household waste. Return the product to
your local recycling facility or contact your
municipal office.
• Discard correctly the packaging material.
Recycle the materials with the symbol
.
contin-
to change the set-
596 / 818 - 898 / 550
220-240 V
50 Hz
(0.5 / 0.05 ) / (8 / 0.8 )
max. 60 °C
12
0.10 W
0.10 W